This gearmotor is a compact (1.50" x 0.59" x 0.47"), high-quality motor with 35:1 metal gearbox. These units have a 0.365"-long, 3 mm-diameter D-shaped output shaft that matches the micro metal gearmotor output shafts.
Oversikt
This motor has a long (0.365" or 9.27 mm, not 8mm as shown in the drawing below), 3 mm-diameter D-shaped metal output shaft that matches our assortment of Pololu wheels and the Solarbotics RW2 rubber wheel. Alternatively, you can use the Pololu universal mounting hub to mount custom wheels and mechanism to the micro metal gearmotor's output shaft.
The brass faceplate has two mounting holes threaded for M2 screws (2 mm diameter, 0.4 mm thread pitch).
These motors are intended for use at 9 V, which means you can get more speed and torque out of this motor than is listed in the 6 V specs. In general, these kinds of motors can run at voltages above and below this nominal voltage, so they should comfortably operate in the 3 – 12 V range (the motor can begin rotating at voltages as low as 0.5 V). Lower voltages might not be practical, and higher voltages could start negatively affecting the life of the motor.
At 6 V, this gearmotor will have a no-load RPM of around 350 with a free-run current of 70 mA, a stall current of 1.5 A, and a stall torque of around 14 oz-in (1 kg-cm).
Dokumenter
| Brukermanual |  |
Kjøp
| Mini Metal Gearmotor | kr. 199,- |
Produkter merket * er bestillingsvare, og det må påregnes noe leveringstid. Alle priser er bruttobeløp inklusive norske avgifter/MVA og oppgitt i NOK. Frakt kommer i tillegg. Ved forsendelser utenfor Norge kan det tilkomme lokal VAT og tollavgifter.
